Tech Tips
If you are wondering what would make a good upgrade to your current set there are some recommendations here based on our experience. We also see many different issues and often come up with solutions that make our lives a bit easier and can help you work out what to do. If you get stuck and want some advice either call or drop into the workshop.
I recently had an issue with a bike that came in for an upgrade to the gearing so the owner could climb hills a bit easier. I had the view that Shimano is always consistent and that most parts are mix and match when it comes to pull ratios on the shifters. The bike had 10 speed Dura ace shifters and a short cage derailleur. I purchased a Tiagra 10 speed medium cage 4700 derailleur and proceeded with the upgrade. I spent hours trying to get the set up right, even engaged another mechanic to take a look and came to the conclusion that it would not work. I then found this article on mixing groupsets that was a great help confirming my fears that I had wasted lots of time trying to get a derailleur to work that had different ration pulls on the cable. If it had been Campagnolo I would have checked earlier!
Mountain bike gearing has been changing significantly in recent years with rear cassettes getting bigger and bigger. My old Whyte E120 originally was set up with 2x9, I set this up as 1x9 with a Race Face 32 up front and and 11/34 on the rear. The gearing was ok but a bit short at either end. Hence the introduction of the Shimano M8000 series bought the upgrade to 1x11 within budget.
This can be a major problem and having had personal experience; it can occur pretty quickly if you are riding in mucky weather or mountain biking and washing your frame down frequently. The best way to avoid this problem is to ensure that you seatpost is protected either with grease or if its a carbon post then a carbon assembly paste.
Freewheels are threaded so that as you apply pressure to the pedals the tendency is to tighten the thread. This of course makes good sense as you wouldn't want it undoing as you pedaled. However this design also can lead to the thread being particularly difficult to undo and can be frustrating as you strain with wheel on the floor. We have come up with a cunning plan to solving this problem...
