The post should be completely removed apply a thin layer of grease or assembly paste and reinstalled; movement should be checked weekly and reapply your protective layer once a month in the winter. Should you have a problem here are some potential solutions:-
If you find the seat post is stuck then there are a variety of freeing techniques, some of these are destructive of the seatpost and if you're not careful can ruin your frame, if you are not sure pop your bike into our workshop and we can take a look.
- Loosen the clamp and apply pressure via the saddle both clockwise and anticlockwise. If it starts to move then work it back and forth and upwards until it releases. Clean it off, clean out the inside of down tube also. Apply a coat of grease/paste and pop it back in check its reasonably free before tightening.
- Ok if it's not shifted then if its a Metal post then apply some penetrating/releasing oil. Leave for 24 hours and retry step 1. If it's not freed then apply heat from a blow torch/heat gun to the seatpost being careful not to damage the frame. You may need to do try these approached a number of times before the post frees up. An alternative approach adopted by one of my customers who had an aluminium post stuck in a steel frame is to dissolve the the seat post with caustic soda. Please note: this involves using some pretty unpleasant chemicals and produces hydrogen as a by product so must be done in a ventilated area and if your frame is aluminium that would be dissolved too, do not attempt this if you are not well versed on using chemicals and appropriate protective clothing.

- If its not shifted and its a Carbon post it can possibly be removed by using an agent such as coca cola to try to dissolve the oxidised compound that is stopping it moving. Use something like a latex glove attached with insulating tape to make a seal around the frame below the level where the seatpost fits into the frame. Fill it up with coke and leave it for 48 hours. Repeat step 1. Again this may not work in which case you can try either step 4 or carbon posts can be cut out using a hacksaw blade. Carbon fibre dust is a carcinogen and protective equipment must be used to avoid inhalation. The post can be cut above the frame seat tube and then carefully cut from the inside avoiding cutting into the frame. The carbon fibre can then eventually be peeled away from the inside. This is a long and tedious job (took me a day on my mountain bike).
- If this approach doesn't work then if the frame is worth saving the post can be reamed out, this is a specialist job and may cost upwards of £100 plus any costs for stripping the frame, however if you have a nice frame it can be worth doing.
If you are at a loss as to what to do please call us, we can help or give advice.
