Mountain bike gearing has been changing significantly in recent years with rear cassettes getting bigger and bigger. My old Whyte E120 originally was set up with 2x9, I set this up as 1x9 with a Race Face 32 up front and and 11/34 on the rear. The gearing was ok but a bit short at either end. Hence the introduction of the Shimano M8000 series bought the upgrade to 1x11 within budget.
Sram and Hope both have wide range gearing in this space, however the price point for these solutions can be a bit prohibitive as both use bespoke freehub bodies allowing for 10 teeth on the top end cassette gear. The Shimano M8000 series allows you to upgrade with no change of freehub, so if you have 9 or 10 setup now the 11 speed cassette will bolt straight on.
To give me high end gearing I chose a 38 tooth Race Face narrow wide front chainring (These feature alternating tooth profiles for surprisingly impressive chain security without a chain guide) 11/42 rear cassette and M8000 shifter and rear derailleur with clutch mech. The total parts cost was £240 utilising the existing crank set. I am running a Next SL carbon crank set. Most Shimano cranksets can take this adaptation.
The Benefit
I set out on this new set up to ride a standard training ride against my Garmin virtual partner. The top big ring is great, only really spinning out on some road downhill sections but not until I was over 30mph. The gear spacing was much better than my old 1x9 set up but with the obvious simplicity of the 1x11 single control. A bit of weight saving having dumped the chain guard, to date I haven't had any chain mishaps. In terms of performance I did an immediate personal best on the route taking several minutes off the 24 mile route. I used the same set up on the Kielder 101 and had no problems with low the gearing up hills.
